Eljer 015-0005 Specifications download pdf (Page 4)

Installation Procedures

Installation must comply with local and national codes.

INSTALLATION PLANNING AND PREPARATION

1. NEVER LIFT THE TUB BY THE PLUMBING. Doing so can result in leaks.

2. Check if the oor is level and of good quality. An uneven oor may impede proper installation of the product. The oor

structure must be capable of supporting at least 100 pounds per square foot.

a. Clean the area of any debris or trash.

b. Use a 5 or 6 foot level and determine if the oor is level. If it is not, calculate how much mortar you have to use to

level the tub.

c. Ensure that you place the drain rough at the proper location.

d. Check if the installer placed the proper electrical service near the pump location. See electrical requirements for

specications.

3. If this is a deck installation, measure from the oor to the bottom of the rim to ensure that the tub is not suspended by its rim.

You should always have the entire tub oor fully supported. *Heights shown below will vary depending on the

amount of settng compound and/or mortar used.

WARNING: When installing Whirlpools, Air, or Total

Massage Baths, observe basic precautions, including the

following:

• DANGER: RISK OF ELECTRICAL SHOCK!

Connect only to a separate circuit protected by a

ground fault circuit interrupter (GFCI)

• Installation must provide access for servicing pump/motor.

1. Install tub waste/ overow tting according to manufacturer’s instructions provided.

-4-

MODEL

LENGTH WIDTH OVERALL HEIGHT “A” “B”

HEIGHT* TO LIP*

Cypress 015-0005 60” 32” 20” 18 1/2” 10 1/4” 16”

Madison 015-0015 60” 32” 20” 18 1/2” 10 1/4”

16”

Patriot 015-0105, 015-0109 60” 32” 19 3/4” 18 3/4” 9 1/2” 16”

Canterbury 015-0025

60” 36” 19 3/8” 17 7/8” 10 1/4” 18”

Emblem 015-0074, 015-0075 72” 36” 19” 17 1/2” 10 1/2” 18”

Preston 015-3704, 015-3705 69” 38” 23” 22” 9 1/8” 34 1/2”

Sheridan 015-0035 58” 38” 20 1/2” 19” 7 3/8” 19”

Genesis 015-5404, 015-5405 71 1/2” 42” 22” 20” 10” 35 3/4”

Laguna 015-0045 60” 42” 20” 18 1/2” 9 3/8” 21”

Venice 015-2504, 015-2505 72” 42” 23” 21 1/2” 10 3/4” 36”

Triangle 015-0065 60” 60” 21” 19 1/2” 35 1/2” 35 1/2”

Casanova 015-4804, 015-4805 60” 60” 21” 19 1/2” 36” 36”

Illustration D

Illustration F

1 2 3 4 5 6 7 8 9

No comments

Eljer 015-0005 Specifications Page 4